seanvx

Hi is there a guide on bleeding clutch on a blob sti , I want to fit a braided clutch line thanks

The Rig

iTrader: (13)

No Guide but all i did was remove TMIC, connect hose to the slave cylinder bleed nipple and bleed like you would the brakes, someone presses clutch pedal down 2 or 3 times, open the bleed nipple, ( with pedal still pressed down ) , tighten the nipple, then the other person pulls the clutch pedal back from the floor and repeats ( mine never used to spring back up once i bled, until pulled up )

TECHNOPUG

iTrader: (1)

There are 2 bleed nipples IIRC.

Don Clark

By the book