Farjay....

Hi, i have a subaru impreza ej20kd. its misfiring, smocking black smoke and fuel consuption is high anyone knows the problem

1509joe

iTrader: (2)

Boost pipe off

Farjay....

Boost pipes are all good.

yabbadoo4

iTrader: (8)

a bit more info is needed bud. is it a standard or modified car? if so what mods and was it mapped for them? decats, front mounts, induction kits etc need to be mapped to correct the reading to the ecu. if standard car the maf might be dirty and need a clean, theres you tube videos showing how to do it. could be the front lambda sensor also. if its a classic you could connect the connectors under the steering wheel to see if theres any codes.

yabbadoo4

iTrader: (8)

as said check all vac pipes for leaks or pipes popped off. extra air entering somewhere will cause the ecu to compensate and add more fuel. any changes made to the car recently?

Farjay....

The car is stock no any mod.

Farjay....

will try to cleaning the maf and check all the vac pipes.

Gambit

iTrader: (6)

what year is the car?

Don Clark

Looks to be a JDM MY97 or 98 WRX

Farjay....

Its 1997

AS Performance

iTrader: (4)

go back to basics and undertake a compression test, those symptoms at first glance would suggest a piston / cylinder issue.............

Farjay....

i just figured out the problem yesterday. it was the airflow sensor wires were not properly insert the car now is boosting properly and no black smock and not misfiring.

yabbadoo4

iTrader: (8)

great result m8. nice one.

Farjay....

Can i map my stock ecu for ej20kd gc8. will the ecu handle and not bring up problems?

Farjay....

Can i map my ecu gc8 ej20kd? Will the ecu handle and not bringing up problems?

bigsigh

iTrader: (4)

you can map the standard ECU with the addition of an ESL daughterboard

http://www.enduringsolutions.com/sho...556/category=0

Farjay....

Hi my Subaru release bearing keep coming out not locking on the pressure plate anyone knows the problem or what should i do.

Farjay....

Hi my Subaru release bearing keep coming out not locking on the pressure plate anyone knows the problem or what should i do.