When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just snapped my speed sensor while trying to remove it (why make it out of plastic ffs)
What will happen if I drive without it? I can put an old broken 2 wire in the hole so the oil wont come out.
Just snapped my speed sensor while trying to remove it (why make it out of plastic ffs)
What will happen if I drive without it? I can put an old broken 2 wire in the hole so the oil wont come out.
The check engine light will come on for a speed sensor fault and drop the cr in limp mode
buy a new one from ashburton subaru and make sure you fit it properly, i use a spanner open ended cut down in half with a angle grinder, makes it so much easier
buy a new one from ashburton subaru and make sure you fit it properly, i use a spanner open ended cut down in half with a angle grinder, makes it so much easier
it was a couple of years ago, maybe it was old stock but i did order the wagon 1/4panels at £126 a side at the same time was told they flagged up as red stock
so i bought both sides, the are the same as far as repairing the arches goes
As a worst case scenario you can simply send the wire that goes to the ecu to earth. The car won't go into limp mode you will just have some strange issues. Such as stalling at lights when you dip your clutch.