engine identification
Hay guy not sure if my engines been swapped so looking to find out what's in it I have the engine code off the block by the bell housing is there anywhere I can find out what it is from this number.
Last edited by mark.125; May 1, 2015 at 05:14 PM.
So been in contact with Subaru uk over Facebook and they where more than helpful they checked reg against chassis number and against engine number.
So seems I have a engine swap and its not from a UK car is there anyway to check against imports have seen 205 on the block so its a long shot but really hopeing its got a closed deck block are there any way of telling this without taking apart
So seems I have a engine swap and its not from a UK car is there anyway to check against imports have seen 205 on the block so its a long shot but really hopeing its got a closed deck block are there any way of telling this without taking apart
Last edited by mark.125; May 8, 2015 at 05:25 PM.
Closed deck block can be identified by the cross hatching on :
Above the modine.
Below the oil pressure switch.
On the block oil feed for the Right hand cylinder head ( drivers side ).
Half moon hatching on bell housing adjacent to starter motor.

Mick
Above the modine.
Below the oil pressure switch.
On the block oil feed for the Right hand cylinder head ( drivers side ).
Half moon hatching on bell housing adjacent to starter motor.
Mick
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
Dec 28, 2015 11:07 PM



