Power steering banjo bolt
01 April 2015, 07:07 PM
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Jan 2014
Location: Now in Thanet
Posts: 806
Likes: 0
Received 0 Likes
on
0 Posts
Power steering banjo bolt
Hi all quick question
I have replaced my power steering pump, and I marked on the banjo bolt what way the holes are facing, but when tightening it back up the holes on the bolt don't face in line with the power steering pipe - If that makes sense?
I cant tighten it up anymore, and if I loosen it to get them in line its too loose.
Question is do they have to line up?
If yes then anyone know a solution to this?
Cheers
Alex
I have replaced my power steering pump, and I marked on the banjo bolt what way the holes are facing, but when tightening it back up the holes on the bolt don't face in line with the power steering pipe - If that makes sense?
I cant tighten it up anymore, and if I loosen it to get them in line its too loose.
Question is do they have to line up?
If yes then anyone know a solution to this?
Cheers
Alex
Last edited by CutMasterT; 01 April 2015 at 07:08 PM.
01 April 2015, 07:40 PM
#2
Scooby Regular
Join Date: Oct 2010
Location: Kings Norton, birmingham
Posts: 1,094
Likes: 0
Received 0 Likes
on
0 Posts
Shouldnt matter as inside the banjo fitting there is a groove covering the ID of the banjo . so oil can still circulate whatever the position of the bolt as it lines up with the holes on the bolt
Thread
Thread Starter
Forum
Replies
Last Post