Replacing exhaust crossover pipe gaskets
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Jul 2013
Location: Colchester
Posts: 665
Likes: 0
Received 0 Likes
on
0 Posts
Replacing exhaust crossover pipe gaskets
Hi All,
I've got a slight blow from one of my exhaust crossover gaskets on my 1993 WRX (stock manifold) and wondering if it's possible to replace these gaskets leaving the headers and up-pipe in place? In theory it should be possible as the crossover pipe unbolts, but not sure if there will be enough space to get the gaskets in position properly.
I've recently replaced the up-pipe gaskets hence not wanting to disturb this, and also given the headers probably haven't been touched in 21 years I don't want to disturb these either if I don't need to!
I've got a slight blow from one of my exhaust crossover gaskets on my 1993 WRX (stock manifold) and wondering if it's possible to replace these gaskets leaving the headers and up-pipe in place? In theory it should be possible as the crossover pipe unbolts, but not sure if there will be enough space to get the gaskets in position properly.
I've recently replaced the up-pipe gaskets hence not wanting to disturb this, and also given the headers probably haven't been touched in 21 years I don't want to disturb these either if I don't need to!
Last edited by 328isport; 21 February 2015 at 06:48 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Bazil_SW
Engine Management and ECU Remapping
24
21 September 2015 11:55 PM