Removing side feed injectors?
22 February 2015, 07:50 PM
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Oct 2013
Location: Stockport
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
Removing side feed injectors?
How do you remove the side feed injectors from the fuel rails once you have removed the caps from them?
I just wanted to ask if there is anything special I need to do in order to remove them as they are extremely reluctant to come out.
I have removed the fuel rails from the engine before anyone asks.
Cheers,
Andy.
I just wanted to ask if there is anything special I need to do in order to remove them as they are extremely reluctant to come out.
I have removed the fuel rails from the engine before anyone asks.
Cheers,
Andy.
23 February 2015, 03:28 AM
#4
Yep I had to use pliers. But carefully!
Make sure to use new upper and lower o-rings when fitting again as well as the seals between the rail and intake. Fit carefully to avoid catching any or rings. You could be fine with the old ones but if fuel leaks past you will wreck the engine. Seen a few people who have had injector seals go and flood the engine.
Make sure to use new upper and lower o-rings when fitting again as well as the seals between the rail and intake. Fit carefully to avoid catching any or rings. You could be fine with the old ones but if fuel leaks past you will wreck the engine. Seen a few people who have had injector seals go and flood the engine.
Thread
Thread Starter
Forum
Replies
Last Post
hedgecutter
General Technical
3
25 September 2015 02:35 PM