Flat boot floor advice please
#1
Scooby Regular
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: Stroke it baby!
Posts: 33,828
Likes: 0
Received 0 Likes
on
0 Posts
Flat boot floor advice please
I'll hopefully be tackling this job next weekend, how much did you guys cut away of the actual floor?
I have a sheet of ally to replace with, is this just bonded in place or should I use rivets or any other kind of fixing?
I have a sheet of ally to replace with, is this just bonded in place or should I use rivets or any other kind of fixing?
#2
Scooby Regular
iTrader: (2)
I would just cut out enough to remove the spare wheel well leaving a flat surface. How thick is your ali?
I would use a good adhesive sealant and ali pop rivets too.
Of course once you have a flat boot floor there will be a natural area towards the rear of the car which will act as an air dam unless you do a defuser or cut that away too.
I would use a good adhesive sealant and ali pop rivets too.
Of course once you have a flat boot floor there will be a natural area towards the rear of the car which will act as an air dam unless you do a defuser or cut that away too.
Last edited by FMJ; 28 October 2014 at 08:07 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM