STi9 block with H beam rods. Good for what power?
30 June 2014, 09:21 PM
#1
Scooby Regular
Thread Starter
Join Date: Jun 2009
Posts: 192
Likes: 0
Received 0 Likes
on
0 Posts
STi9 block with H beam rods. Good for what power?
I have an STi 9 2.0 S20C block in my JDM WRX, so it has the AVCS heads too.
My block has standard pistons but H beam rods and ACL bearings. What sort of power would this be good for?
Ive got an S206 turbo and downpipe here, I know its a bit overkill but what would be a safe bhp to have it mapped to? 450ish?
My block has standard pistons but H beam rods and ACL bearings. What sort of power would this be good for?
Ive got an S206 turbo and downpipe here, I know its a bit overkill but what would be a safe bhp to have it mapped to? 450ish?
01 July 2014, 02:08 AM
#2
Hi there
We run JDM WRX block(converted to 2.1) with AVCS heads at 490bhp,not sure what I would say how much yours engine or can't take
What pistons and what make of rods you are running?
Are you running ARP headstuds?
I would say 450bhp should be OK,but really hard to say if will or can be OK,but on standard pistons not sure if I would go far as that
Thanks,Jura
We run JDM WRX block(converted to 2.1) with AVCS heads at 490bhp,not sure what I would say how much yours engine or can't take
What pistons and what make of rods you are running?
Are you running ARP headstuds?
I would say 450bhp should be OK,but really hard to say if will or can be OK,but on standard pistons not sure if I would go far as that
Thanks,Jura
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
MH-Racing
Subaru Parts
18
18 October 2015 04:49 PM