ecu advice please
#1
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Nov 2011
Location: Ireland
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
ecu advice please
Hi guys
any one have any experience with the autotronic ecu? are they any good? have a 97 ver3 sti on apexi power fc, want to go maffless, autotronic for sale on here with ait sensor but no mapping leads... whats an ait sensor? tried to google mapping leads to no avail.. are they hard to get? are they expensive? What else should come with it?
do I just unplug the maff and take out?
Thanks in advance for your help.
any one have any experience with the autotronic ecu? are they any good? have a 97 ver3 sti on apexi power fc, want to go maffless, autotronic for sale on here with ait sensor but no mapping leads... whats an ait sensor? tried to google mapping leads to no avail.. are they hard to get? are they expensive? What else should come with it?
do I just unplug the maff and take out?
Thanks in advance for your help.
#2
Scooby Regular
iTrader: (9)
Join Date: Oct 2003
Location: InTheSticks
Posts: 6,120
Likes: 0
Received 0 Likes
on
0 Posts
It's an Autronic.
Mapping cable can be easily made with a serial cable and a 3.5mm headphone jack. - if you dont want to make a cable, Mark Shead (MA Developments) should be able to help you with a cable and a suitable IAT sensor.
It's a dated Ecu, but still very capable. - the most important thing is to find somebody who is experienced at mapping it, to ensure you get a good and well configured map for your car.
Mapping cable can be easily made with a serial cable and a 3.5mm headphone jack. - if you dont want to make a cable, Mark Shead (MA Developments) should be able to help you with a cable and a suitable IAT sensor.
It's a dated Ecu, but still very capable. - the most important thing is to find somebody who is experienced at mapping it, to ensure you get a good and well configured map for your car.
Last edited by little'un; 15 December 2013 at 09:35 PM.
#3
Scooby Regular
Thread Starter
iTrader: (3)
Join Date: Nov 2011
Location: Ireland
Posts: 72
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Littleun, sorry about the spelling, what is and where does the sensor go? is there any other sensors that should come with it? when fitted can i just unplug and remove the maff?
Sorry if questions seem thick.
Thanks again.
Sorry if questions seem thick.
Thanks again.
#6
Scooby Regular
#7
The boards for 92-6 and 97-8 are different.
www.facebook.com/EnduringSolutionsLtd
www.enduringsolutions.com/InfoSheet.pdf
www.enduringsolutions.com/Manual.pdf
www.youtube.com/watch?v=8AJAUA_F89s
www.facebook.com/EnduringSolutionsLtd
www.enduringsolutions.com/InfoSheet.pdf
www.enduringsolutions.com/Manual.pdf
www.youtube.com/watch?v=8AJAUA_F89s
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
Phil3822
General Technical
0
30 September 2015 06:29 PM