Anyone kinda enough to share shape of ignition map?
#1
Scooby Regular
Thread Starter
Anyone kinda enough to share shape of ignition map?
Hi,
I have been battling with my Ignition map for over a year now! It started off as a Standard 6K map which was extended to work for 1.5 bar.
The car is a forged Ej20 with a TD05-20G (billet). Hoping for near 400hp.
The map I have is working, But I think I am still missing some concepts! Anyone care to share a similar map or suggest where I am going wrong.
I am running 98 octane gas 11.5:1 AFR , FMIC and compression of approx 8.5:1
Any help would be great! As I am living in a country where a dyno doesn't exist and slowly running out of ideas!!
The map is scaled
Load<20 Vacuum
Load 20= 0 Bar
Load 38=1.0 Bar
Load 47=1.5 Bar
I have been battling with my Ignition map for over a year now! It started off as a Standard 6K map which was extended to work for 1.5 bar.
The car is a forged Ej20 with a TD05-20G (billet). Hoping for near 400hp.
The map I have is working, But I think I am still missing some concepts! Anyone care to share a similar map or suggest where I am going wrong.
I am running 98 octane gas 11.5:1 AFR , FMIC and compression of approx 8.5:1
Any help would be great! As I am living in a country where a dyno doesn't exist and slowly running out of ideas!!
The map is scaled
Load<20 Vacuum
Load 20= 0 Bar
Load 38=1.0 Bar
Load 47=1.5 Bar
Last edited by Dmacnz; 02 December 2013 at 03:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
toyney83
General Technical
10
02 October 2015 08:38 PM
Flat4x4-again
General Technical
2
29 September 2015 06:32 PM