gixxerjoe

i have just bought the above car and it’s been mapped how can I find out who has mapped it as it has got a lot of codes for ignition timing etc due to the map and want to find out who done it to get them sorted. Thanks

TECHNOPUG

iTrader: (1)

Do you have any receipts? Sounds like it was badly mapped so you'd be better off taking it to someone reputable and having it mapped from scratch.

gixxerjoe

Peedee

iTrader: (4)

I wouldn’t go throwing mods onto it if you’ve got faults already. Save the mods for when it’s being mapped again so the mapper can factor them in.

bludgod

iTrader: (3)

are you sure the codes are due to the map and maybe not some fault that has developed? What codes are you getting?

gixxerjoe

i will pull the codes off later and past them up on here.

ossett2k2

iTrader: (9)

Might not have been mapped,any signs of a bleed valve/dawes device fitted?

gixxerjoe

were would I find that. The reason I think it’s mapped is that it’s a bit quick for a std 225 bhp Car.

bludgod

iTrader: (3)

look for out of place things under the bonnet near or attached to the turbo most likely. Might even be easier to drop the car into a specialist and have them tell you what's non-standard? Failing that throw a load of engine bay pics up and maybe someone can spot something not right.

ossett2k2

iTrader: (9)

This^^^^^

A bleed valve will make it feel fast but usually the engine doesn't last too long.
Are these fault codes live or stored codes?
Done an ecu reset?

gixxerjoe

no the engine is defo std nothing been touched under there. The codes are saying historic on them. How do I do a ecu reset than.

ossett2k2

iTrader: (9)

http://www.scoobypedia.co.uk/index.p...ledge/ECUReset

gixxerjoe

cheers.