Positions of Various connectors
#1
Scooby Regular
Thread Starter
Join Date: Mar 2006
Location: Been roller coasting for a long time and can't get off.
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
Positions of Various connectors
Using the 'JollyGreenMonster' Pinout page for the Control Module I/O Signals for a MY92~MY96 Impreza Turbo.
As I am having problems where the Engine light is coming on when overruning down hill along with alot of popping/banging in exhaust, but if I put clutch is down for a few seconds at idle this clears the light.
So firstly I want to check the TPS, MAF, Oxygen, IAVC voltages at the Control Module connectors B95, B43 and B44. I am going to clean the MAF and IACV firstly as suggested at various posts seen before testing their voltages.
I take it these connectors shown, are at the control unit under the dash on R/H, where the error codes are found.
Also any another sensor voltage I should check with this problem I have. ?
thanks
As I am having problems where the Engine light is coming on when overruning down hill along with alot of popping/banging in exhaust, but if I put clutch is down for a few seconds at idle this clears the light.
So firstly I want to check the TPS, MAF, Oxygen, IAVC voltages at the Control Module connectors B95, B43 and B44. I am going to clean the MAF and IACV firstly as suggested at various posts seen before testing their voltages.
I take it these connectors shown, are at the control unit under the dash on R/H, where the error codes are found.
Also any another sensor voltage I should check with this problem I have. ?
thanks
Last edited by mightyscoob; 29 April 2014 at 08:14 PM.
#2
Scooby Regular
Thread Starter
Join Date: Mar 2006
Location: Been roller coasting for a long time and can't get off.
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
OK I'll ask another question to above.
With the 'JollyGreenMonster' picture for the 'Control Module I/O Signal's for a MY92~MY96 Impreza Turbo.
It shows B43, B44 and B95 connectors for checking the voltages of various items.
Are these 3 connectors under the dashboard, where we connect the 2 black plugs for finding the error codes. Or elsewhere. ??
With the 'JollyGreenMonster' picture for the 'Control Module I/O Signal's for a MY92~MY96 Impreza Turbo.
It shows B43, B44 and B95 connectors for checking the voltages of various items.
Are these 3 connectors under the dashboard, where we connect the 2 black plugs for finding the error codes. Or elsewhere. ??
Thread
Thread Starter
Forum
Replies
Last Post