help urgent
26 March 2002, 05:13 PM
#1
Scooby Regular
Thread Starter
Join Date: Sep 2000
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
i have found out that i have had a hks boost controller fitted at some time but has been taken out but wires left there would this cause any problems also wont to fit a dawes device but pipes goto this hks device under bonnet were does the pipe from the bleed niple goto originally and does the vacuum pipe for guage go straight into manifold
26 March 2002, 06:53 PM
#2
Scooby Regular
Thread Starter
Join Date: Sep 2000
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
i need to blank of two pipes one that goes to the waste gate and one which goes to the turbo nipple but the pipe from the boost controller are there do i just take these of and blank them and then put the dawes device in place ? if the boost controller was not thre would the pipe from the waste gate go to the turbo nipple ?
27 March 2002, 07:56 AM
#4
Scooby Regular
Thread Starter
Join Date: Sep 2000
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
its a 94 wrx i will try and get pictures
i am trying to find out were the vacuum hose to the waste gate go from standard and were the vacuum hose from the exhaust turbo pipe has a little nipple on it for another vacuum hose .so i can fit a manual boost controller as mine is connected up for an electronic controller which is not there
i am trying to find out were the vacuum hose to the waste gate go from standard and were the vacuum hose from the exhaust turbo pipe has a little nipple on it for another vacuum hose .so i can fit a manual boost controller as mine is connected up for an electronic controller which is not there
Thread
Thread Starter
Forum
Replies
Last Post
Blow Dog
Non Scooby Related
4
16 September 2001 12:22 PM