Ecutek upgrade - BHP / Torque Graph
#2
That's one fat torque curve ! I'm booked in for the Tek2 on Thursday evening. I'll post my maps on Friday if I can figure out the upload thingy.
Andy.
MY00. Full SS system. K&N Induction Kit.
Andy.
MY00. Full SS system. K&N Induction Kit.
#4
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: Cheshire
Posts: 2,569
Likes: 0
Received 0 Likes
on
0 Posts
From a boost gauge..... I have somewhere between 15.5 to 16 PSI held.
I will confirm this when I get hold of the new Ecutek software and test the car.
J
I will confirm this when I get hold of the new Ecutek software and test the car.
J
#6
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: Cheshire
Posts: 2,569
Likes: 0
Received 0 Likes
on
0 Posts
Car is a MY00 with S.S downpipe, Magnex centre and backbox. No other engine mods. Car was running on Super Unleaded for the rolling road.
Car had an AE802 standard ECU to start, and then was upgraded to the Tek2
J
Car had an AE802 standard ECU to start, and then was upgraded to the Tek2
J
Trending Topics
#8
Scooby Regular
Thread Starter
Join Date: Dec 2001
Location: Cheshire
Posts: 2,569
Likes: 0
Received 0 Likes
on
0 Posts
Hi Gavin,
Yep I've used Optimax (98.5) for the last 4 months rather than Super (97).
However I beleive that one of the maps on the ECU is for 95Octance unleaded and is used when the car senses to much knock.
Stephen can you confirm?
Thanks
J
Yep I've used Optimax (98.5) for the last 4 months rather than Super (97).
However I beleive that one of the maps on the ECU is for 95Octance unleaded and is used when the car senses to much knock.
Stephen can you confirm?
Thanks
J
Thread
Thread Starter
Forum
Replies
Last Post
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM