Driveshaft hub fitments
#1
Driveshaft hub fitments
I am converting a 1998 2.5 legacy engine and gearbox to to run as a mid mount + transaxle in a build project. I had intended to use the hubs off the donor car I bought but they have turned out to be too corroded to really be fit for the job.
What other models hubs will the legacy rear shafts fit? Are they interchangeable or will I, if say I get Impreza hubs, have to get the shafts of the same model to fit?
I am already having to cut and splice to use the front drive outputs to make up the new shafts but I would rather avoid the expense of getting more rears if avoidable.
The shafts I have are from a 98 2.5 4cam outback - uk spec
Thanks
Phil
What other models hubs will the legacy rear shafts fit? Are they interchangeable or will I, if say I get Impreza hubs, have to get the shafts of the same model to fit?
I am already having to cut and splice to use the front drive outputs to make up the new shafts but I would rather avoid the expense of getting more rears if avoidable.
The shafts I have are from a 98 2.5 4cam outback - uk spec
Thanks
Phil
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
KK3960
General Technical
3
07 October 2015 12:33 PM