Torque Setting for Knock Sensor
01 March 2002, 09:23 AM
#2
Scooby Regular
Join Date: May 1999
Location: SSO2003 2nd, SSO2005 1st, SSO2006 2nd, TACC Rd4 5th 4wd: In my car ;-)
Posts: 2,637
Likes: 0
Received 0 Likes
on
0 Posts
Scott,
It's more a case of not doing it up too tight. The torque setting is 4.7lbs +/- .4lbs. Just give it a light nip, and it'll be fine.
Mark.
It's more a case of not doing it up too tight. The torque setting is 4.7lbs +/- .4lbs. Just give it a light nip, and it'll be fine.
Mark.
01 March 2002, 11:21 AM
#3
Scooby Senior
Join Date: Oct 2000
Location: Zurich, Switzerland
Posts: 3,105
Likes: 0
Received 0 Likes
on
0 Posts
Is there a better place to fit it than on the right hand side (looking at engine) front intercooler bracket (inlet manifold)?
I rarely see more than 1st/2nd led's on max sensitivity - tapping around the sensor lights the red.
Thanks
Richard
I rarely see more than 1st/2nd led's on max sensitivity - tapping around the sensor lights the red.
Thanks
Richard
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
charlesr
General Technical
9
28 September 2015 09:16 AM
aaron_ions
General Technical
1
17 September 2015 10:42 AM