Thrust bearing perhaps on my MY02 Sport
#1
Thrust bearing perhaps on my MY02 Sport
After a bit of searching on here, it sounds as if the thurst bearing has gone on my clutch
When ever the clutch peddle is depressed and reaches the biting point, there is a horrible grinding noise, like the noise you hear if your break pads run down completley.
What do you think, thrust bearing?
It goes into the dealers on Monday
When ever the clutch peddle is depressed and reaches the biting point, there is a horrible grinding noise, like the noise you hear if your break pads run down completley.
What do you think, thrust bearing?
It goes into the dealers on Monday
#4
Originally Posted by R19KET
Could be, or maybe you've worn the clutch out !
Mark.
Mark.
You got me worried now Only done 3000 miles since I brought it, as a proven Subaru from a main dealer
#5
Scooby Regular
Join Date: May 1999
Location: SSO2003 2nd, SSO2005 1st, SSO2006 2nd, TACC Rd4 5th 4wd: In my car ;-)
Posts: 2,637
Likes: 0
Received 0 Likes
on
0 Posts
I'm sure they'll sort it out, and yes, I would expect it to slip if it was that worn.
It may well be the release bearing, which isn't too expensive, but does the need the gearbox removing to fit it.
It's also pretty hard to say just what it is, without actually hearing it.
Mark.
It may well be the release bearing, which isn't too expensive, but does the need the gearbox removing to fit it.
It's also pretty hard to say just what it is, without actually hearing it.
Mark.
#6
Apparently its the spiggot bearing This has caused blueing and cracks to the flywheel, Subaru should cover the cost tho Should be back tomorrow! Meanwhile I'm stuck with a 1.5dci Clio
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM