Phase 1 engine
#1
Phase 1 engine
Preparing a trak car at present and have ran into the following problems....
Just fitted a new version 2 engine to car. While engine was out stripped out clifford p600 larm system every wire was traced to source and disconected.
Engine started off key no probelms but will only run for a couple of seconds and then cut out..............
This is the first scoob engine replacemet we have done checked everything we can think of but still not having any joy!!!!
Anyone make any suggestions on what to check????????
Just fitted a new version 2 engine to car. While engine was out stripped out clifford p600 larm system every wire was traced to source and disconected.
Engine started off key no probelms but will only run for a couple of seconds and then cut out..............
This is the first scoob engine replacemet we have done checked everything we can think of but still not having any joy!!!!
Anyone make any suggestions on what to check????????
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM
bluebullet29
General Technical
9
05 October 2015 02:17 PM
Brzoza
Engine Management and ECU Remapping
1
02 October 2015 05:26 PM