P0546 AND P1312 ERROR CODES
#1
Scooby Newbie
Thread Starter
Join Date: Jun 2003
Location: Barcelona (Spain)
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
P0546 AND P1312 ERROR CODES
I get these error codes in my decated WRX MY01. After reset, the CEL turns on again and remains fixed after few km when i was driving in a motorway in high speed. According list of codes these codes means:
P1312: "Exhaust gas temperature circuit malfunction"
P0546: "Exhaust gas temperature sensor circuit high input"
I´ve read in Nasioc forums that P0546 is typical when is fited an decatted uppipe and it have not solution but make a circuit to fix CEL. I´ve recently blowed up my car and motor is absolutly new (only 2000 Km) and these codes do not seem the classics of decated exhausts. Wath's is your opinion about this. Should i be worried or these codes are really caused by decat exhaust. (naturraly i don't want new "surprises"
P1312: "Exhaust gas temperature circuit malfunction"
P0546: "Exhaust gas temperature sensor circuit high input"
I´ve read in Nasioc forums that P0546 is typical when is fited an decatted uppipe and it have not solution but make a circuit to fix CEL. I´ve recently blowed up my car and motor is absolutly new (only 2000 Km) and these codes do not seem the classics of decated exhausts. Wath's is your opinion about this. Should i be worried or these codes are really caused by decat exhaust. (naturraly i don't want new "surprises"
#4
They are in response to the EGT getting hotter tahn it should as the cats have been removed, though some people wouldn't want the CEL illuminated.
Customer's choice though easy to remedy..........
Customer's choice though easy to remedy..........
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM