Turbo blow where outlet housing meets Exhaust
#1
Scooby Regular
Thread Starter
iTrader: (1)
Join Date: Apr 2002
Posts: 2,808
Likes: 0
Received 0 Likes
on
0 Posts
Turbo blow where Inlet housing meets Exhaust
My Td05 turbo has started chuffing very slightly in between the two turbo housings, These are held together by some sort of crush ring.. Is there some sort of fire ring gasket between these two ?? How much of a job is this to change ??
I had a quick look & it looks like i could just remove / move the inlet side to replace the seal, but would it need a special tool to seal the crush ring ??
Thanks
Dean
I had a quick look & it looks like i could just remove / move the inlet side to replace the seal, but would it need a special tool to seal the crush ring ??
Thanks
Dean
Last edited by DeanF; 10 May 2004 at 05:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
55
05 August 2018 07:02 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
trapper2013
ScoobyNet General
6
30 October 2015 03:10 PM