apexi avcr
#1
Scooby Regular
Thread Starter
Join Date: Oct 2001
Location: aberdeenshire
Posts: 751
Likes: 0
Received 0 Likes
on
0 Posts
apexi avcr
away to fit a apexi avcr to my 93 wrx a bit confused about the standard boost valve do you just disconect it all together cause i was told that when you switch off the avcr you get standard boost how does this work
cheers
cheers
#2
Scooby Regular
Join Date: Jun 2002
Location: Nottingham
Posts: 5,285
Likes: 0
Received 0 Likes
on
0 Posts
if you can- might be worth emailing AndyF ( andyf6000@hotmail.com ) as he is in your neck of the woods -ie:scotland, and he knows plenty about the Apexi unit.. an the Apexi ECu's..
I dont know of any official Apexi dealers up there.. good luck.
hope that helps you out mate..
I dont know of any official Apexi dealers up there.. good luck.
hope that helps you out mate..
#3
You will have to leave the original solenoid valve connected otherwise the check engine light will come on.
The hoses are obviously disconnected from it would recommend taping the holes on the solenoid up to prevent dirt building up in there.
I've actually left my hoses on and in place, just in case I need to remove the AVC-R
When the AVC-R is in "OFF" mode, the boost you get is controlled by the wastegate actuator only, which is around .5 bar. The AVC-R normally bleeds air off the wastegate actuator (hose) to fool it into thinking there is less boost, and therefore it open less and turbo boost increases.
Let me know if you have any problems fitting it
The hoses are obviously disconnected from it would recommend taping the holes on the solenoid up to prevent dirt building up in there.
I've actually left my hoses on and in place, just in case I need to remove the AVC-R
When the AVC-R is in "OFF" mode, the boost you get is controlled by the wastegate actuator only, which is around .5 bar. The AVC-R normally bleeds air off the wastegate actuator (hose) to fool it into thinking there is less boost, and therefore it open less and turbo boost increases.
Let me know if you have any problems fitting it
#5
Originally Posted by Bob Rawle
Leave the factory solenoid and transfer the existing pipework to the AVCR solenoid as that works better than the lerger bore pipe that is supplied.
bob
bob
Thread
Thread Starter
Forum
Replies
Last Post
Mister:E
Subaru Parts
2
24 September 2015 01:37 PM