Aquamist infos needed!
#1
Hello!
I want to use the Aquamist 1s waterinjection on my Car and i want to activate it over the Haltech ECU!
Normally the 1s System is activatet by a pressure switch so my idea was to get the Signal for the Input and search for a same outputr on my Haltech E6X ECU so i can activate the Waterinjetion on some parameters i can adjust in the Haltech!
Anybody knows about the input signal on the 1s System?
I want to use the Aquamist 1s waterinjection on my Car and i want to activate it over the Haltech ECU!
Normally the 1s System is activatet by a pressure switch so my idea was to get the Signal for the Input and search for a same outputr on my Haltech E6X ECU so i can activate the Waterinjetion on some parameters i can adjust in the Haltech!
Anybody knows about the input signal on the 1s System?
#2
Scooby Regular
Join Date: Nov 2000
Location: 32 cylinders and many cats
Posts: 18,658
Likes: 0
Received 1 Like
on
1 Post
The 1s system uses a normally closed pressure switch which keeps pin 2 grounded to keep the pump off.
However, your ECU has four PWM outputs, one of which could be used to convert the system into a 2c with a few extra parts - mainly a pressure regulator. Check the current output capability of the PWM from your ECU as the solenoid is quite beefy. http://www.aquamist.co.uk/cp/mf2manual.zip
Thread
Thread Starter
Forum
Replies
Last Post
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM