Notices
Drivetrain Gearbox, Diffs & Driveshafts etc

wining noise as cluth is released??

Old 02 December 2003 | 01:40 PM
  #1  
Jamo's Avatar
Jamo
Thread Starter
Cooking on Calor
iTrader: (23)
 
Joined: Oct 2001
Posts: 23,346
Likes: 7
From: in a house full of girls!
Question

is it the thrust bearing? any clues???
Old 02 December 2003 | 04:03 PM
  #2  
AlexM's Avatar
AlexM
Scooby Regular
 
Joined: Apr 1999
Posts: 1,035
Likes: 0
Post

Yup...sounds like the release bearing is on it's way out. I had the same problem with my MY98 and it was corrected by replacing the release bearing.

Cheers,

Alex
Old 02 December 2003 | 04:10 PM
  #3  
Jolly Green Monster's Avatar
Jolly Green Monster
Former Sponsor
iTrader: (4)
 
Joined: Jan 2001
Posts: 16,548
Likes: 2
From: ECU Mapping - www.JollyGreenMonster.co.uk
Post

Believe you can solve this by putting some spray grease carefully on the release bearing through the clutch release fork hole..

There was a thread about it the other week..
Hopefully someone will come along and explain further..

but basically you just remove the gaiter from the release fork hole ontop of the gear box and use a very long straw on the spray can and a torch etc.. worth trying for the cost of a can of spray grease rather than gearbox out etc..

JGM
Old 04 December 2003 | 05:14 PM
  #4  
Jamo's Avatar
Jamo
Thread Starter
Cooking on Calor
iTrader: (23)
 
Joined: Oct 2001
Posts: 23,346
Likes: 7
From: in a house full of girls!
Post

thats cool cheers.

had a go at the latter, no use though, just pricing up a new clutch and get it done at the same time.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
johnnybon
Subaru Parts
20
20 March 2016 09:23 PM
Phil3822
ScoobyNet General
33
02 October 2015 03:22 AM
Jamesh10
General Technical
3
01 October 2015 11:56 PM
sivo
ScoobyNet General
12
26 September 2015 12:34 PM
Baskey
General Technical
3
25 September 2015 03:45 PM


Thread Tools
Search this Thread
Quick Reply: wining noise as cluth is released??



All times are GMT +1. The time now is 12:06 AM.