exhaust fitting
27 September 2003, 06:32 PM
#1
Scooby Regular
Thread Starter
Join Date: Jan 2003
Location: P1 0790, Durham TTS
Posts: 952
Likes: 0
Received 0 Likes
on
0 Posts
MY99 UK Turbo. Just removed my standard exhaust. There is no gasket between the back box and the centre pipe. Also, between the centre pipe and the downpipe there appears to be no gaskets. There is a flange fitment between these pipes due to the fact they are held in place by spring bolts. Is there meant to be gaskets or not?
27 September 2003, 06:42 PM
#2
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
There should be gaskets on both, the rear one is not majorly (sp) important but the DP to centre is.
However.... You will find that the DP to centre gaskets is there, its just that it looks like part of the downpipe. Hav ea good look at the Downpipe end, you can just make out that there is a mesh gasket on the end of it. It is a solid/mesh gasket that slots over the end of the downpipe to make it round - to slot into the centre section flange.
Rob
However.... You will find that the DP to centre gaskets is there, its just that it looks like part of the downpipe. Hav ea good look at the Downpipe end, you can just make out that there is a mesh gasket on the end of it. It is a solid/mesh gasket that slots over the end of the downpipe to make it round - to slot into the centre section flange.
Rob
Thread
Thread Starter
Forum
Replies
Last Post
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
Scott@ScoobySpares
Full Cars Breaking For Spares
7
14 December 2015 08:16 AM
KOEScoob
ScoobyNet General
6
17 September 2015 03:51 PM