play in n/s/f wheel bearing advice
#1
Scooby Regular
Thread Starter
Join Date: Mar 2001
Location: uk
Posts: 1,998
Likes: 0
Received 0 Likes
on
0 Posts
just checking the car over and have very slight play on n/s/f wheel. there are no noises yet in use. can the play be taken up in the scoob by nipping it up tighter, or is it replacement time?
on any other car I would say it was fine to leave it , but the car will be getting an **** kicking next weekend.
[Edited by T-uk - 7/27/2003 1:23:15 PM]
on any other car I would say it was fine to leave it , but the car will be getting an **** kicking next weekend.
[Edited by T-uk - 7/27/2003 1:23:15 PM]
#2
If the wheel hub nut had worked loose, you should be worried about why. It requires a lot of torque and has a locking tab, so it shouldnt loosen off. Mine worked loose once, but that was because a certain tuning outfit did a sloppy job whilst changing a driveshaft.
#3
Scooby Regular
Thread Starter
Join Date: Mar 2001
Location: uk
Posts: 1,998
Likes: 0
Received 0 Likes
on
0 Posts
thanks moray,
the locking tab was still where it should be and as far as I know has never been touched.
I gave it a wee tighten,hardly moving it,more centreing (sp) the locking tab in the groove and made sure the locking tab was seated better. will keep an eye on it over the coming days/weeks.
[Edited by T-uk - 7/28/2003 6:52:57 PM]
the locking tab was still where it should be and as far as I know has never been touched.
I gave it a wee tighten,hardly moving it,more centreing (sp) the locking tab in the groove and made sure the locking tab was seated better. will keep an eye on it over the coming days/weeks.
[Edited by T-uk - 7/28/2003 6:52:57 PM]
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM