VF-29 vs TD-05 front entry
#1
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Nov 2000
Location: Norup, Denmark
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
Hi All,
Q ,
If the VF29 can make 320 flywheel hp at 1,3bar tappering to 1,2bar at 7000/rpm,(with all the right parts)
Will the TD05 front entry make more power at the same boost level?????.
Any info would be great,
Skassa
Q ,
If the VF29 can make 320 flywheel hp at 1,3bar tappering to 1,2bar at 7000/rpm,(with all the right parts)
Will the TD05 front entry make more power at the same boost level?????.
Any info would be great,
Skassa
#2
Scooby Regular
Join Date: Nov 2000
Location: 32 cylinders and many cats
Posts: 18,658
Likes: 0
Received 1 Like
on
1 Post
Depends primarily on charge temperature and exhaust gas back pressure.
Charge temperature will depend on heatsoak and compressor discharge temperature.
There is little data on EGBP, but my feeling is that the TD05H hot side is more efficient than the VF29's.
You may get a little more at the same boost from lower charge temp and lower EGBP, but the largest gains when you use a larger turbo are when you were running the previous one outside its hot and cold side efficiency zones.
Charge temperature will depend on heatsoak and compressor discharge temperature.
There is little data on EGBP, but my feeling is that the TD05H hot side is more efficient than the VF29's.
You may get a little more at the same boost from lower charge temp and lower EGBP, but the largest gains when you use a larger turbo are when you were running the previous one outside its hot and cold side efficiency zones.
#3
Scooby Regular
Join Date: Nov 2000
Location: 32 cylinders and many cats
Posts: 18,658
Likes: 0
Received 1 Like
on
1 Post
VF29 is very similar compressor BTW.
I assumed (incorrectly) 100% VE for these on an EJ20. Just to give you an idea. You could plot the same over a TD05 compressor map and work out the compressor efficiency there.
Then you need to put in some assumptions about intercooler density recovery.
[Edited by john banks - 4/24/2003 10:45:32 PM]
#4
Scooby Regular
Thread Starter
iTrader: (2)
Join Date: Nov 2000
Location: Norup, Denmark
Posts: 936
Likes: 0
Received 0 Likes
on
0 Posts
Thanks John,
Well i have just ordered a TD05 from Mark , and i´m getting a costum frontmount made this weekend ,so now i´m just waiting fore the injectors from phase2.
Thanks,
Skassa
Well i have just ordered a TD05 from Mark , and i´m getting a costum frontmount made this weekend ,so now i´m just waiting fore the injectors from phase2.
Thanks,
Skassa
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM