where is the engine coolant sensor
#1
Scooby Regular
Thread Starter
iTrader: (51)
Join Date: Nov 2002
Location: MSOC
Posts: 7,439
Likes: 0
Received 0 Likes
on
0 Posts
I know where the one pronged one is but I don't know where the two pronged one is that goes to the ecu. Also by replacing this will I have to drain the coolant like when fitting the one pronged sensor.
My car is an MY95 WRX.
My car is an MY95 WRX.
#2
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
It is underneath the inlet manifold on a cross pipe that runs from one side of the block to the other and then out to the top rad hose.
If you follow the pipe that the top rad hose goes onto it is about 8 inches back along this pipe and on the back (facing the rear)
Orange connector, pig to get off
Rob
If you follow the pipe that the top rad hose goes onto it is about 8 inches back along this pipe and on the back (facing the rear)
Orange connector, pig to get off
Rob
#4
Scooby Regular
Join Date: May 2002
Location: Scotland
Posts: 2,148
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post