Fitting coolant hoses
24 September 2002, 06:00 PM
#1
Scooby Regular
Thread Starter
I have a set of 8 samco coolant hoses that I would like to fit to my P1. Sadly I'm a bit a technical biff so am not entirely sure how to go about this.
Is there an easy way of doing this? How do you avoid getting airlocks etc in the system?
Any assistance and advice greatfully received!
Ta
Is there an easy way of doing this? How do you avoid getting airlocks etc in the system?
Any assistance and advice greatfully received!
Ta
24 September 2002, 06:42 PM
#2
Scooby Regular
Join Date: Jul 2001
Posts: 507
Likes: 0
Received 0 Likes
on
0 Posts
which kit did u get as i only found a use for 5pcs.rad top and bottom/header tank x3.the others didnt fit..no easy way to do it.header tank is ok just remove fluid using a tube.but for the rad u will have to drain it.best to get it done at ur next service when they can drain and refill the system
24 September 2002, 07:13 PM
#3
Scooby Regular
Join Date: May 2002
Location: Scotland
Posts: 2,148
Likes: 0
Received 0 Likes
on
0 Posts
SAMCO hose fitting
These are kind of easy to do, I got 4 out of the 8 fitted already. The others will get one when I need to take the surrounding bits off.
Good Luck
[Edited by caz1562 - 9/24/2002 7:24:26 PM]
These are kind of easy to do, I got 4 out of the 8 fitted already. The others will get one when I need to take the surrounding bits off.
Good Luck
[Edited by caz1562 - 9/24/2002 7:24:26 PM]
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
Mattybr5@MB Developments
Full Cars Breaking For Spares
33
29 August 2017 07:18 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM