Hi,

Just got my lamdba link does anyone know the best way to fit it, ideally to a MY95 WRX....

It says i have to take an earth off the block and from the chassis.... and then says dont run the signal wire near the coil, leads e.t.c, but the block earth and signal wire are shrink wraped together..... and my signal wire from the o2 sensor is near the coil packs on the left hand side of the engine...???

Any help would be great...

Dan

 

bttt... someone must have one..!



Dan

 

come on peeps..

I want it on today...

The first helpful reply will recieve a bacon sandwich dispatched via royal mail special delivey..... it might be a it bit mouldy..

Dan

 

I think you'd be alright as long as you don't loom the wires in with the coil wires or pass them directly over the coil packs.

 

done it now and it seems to be working fine..!!!!

Thanks

Dan

 

lol, just read this..
No need for manuscript lmao

Rob

 

did you get my mail rob...!!!

Well the thought was there anyway, thanks..!! i just thought sod it ill give it ago and it seems to be working fine...

It seems to go up the scale pretty easy though are they supposed to do that.... i.e at full throttle it will light all the way up to and including the last green led...??

Dan

 

No mail mate?
All the greens is good!!
just the reds is bad
Rob

 

rob

YHM..

 

YHM back
That is... 'You Have Manuscript'

Rob

 

YHM again..sorry..!

Does anyone happen to know which pin at the ECU is the o2 sensor signal wire....

Someone told me before, they said it was pin 6 on B43, however when i got to this pin the wire colour didnt match (white with silver ring around it), this one seems to be pin 7...???

Dan

 

Dan, if you have got a multimeter?? you can test the voltage at the pin?? have to be a digital one though..
Rob

 

no must get one of them..!!

Dan