Any connectors bits needed for different downpipes?
01 August 2002, 08:19 PM
#1
Scooby Regular
Thread Starter
Join Date: Nov 2001
Location: the middle bit
Posts: 8,238
Likes: 0
Received 0 Likes
on
0 Posts
Der mode on with regards whether it needs any particular special bits 2 join on but anyway i'm getting the blitz NURspec centre & back & i am still tempted with a DP while i'm there
So i was told the blitz goes straight on the standard DP, on a MY97 turbo 2000, is it the same with other DP's?
Hmm now if i do which DP's it 2b
Cheers
Si
So i was told the blitz goes straight on the standard DP, on a MY97 turbo 2000, is it the same with other DP's?Hmm now if i do which DP's it 2b
Cheers
Si
01 August 2002, 08:50 PM
#2
Scooby Regular
Join Date: Mar 2002
Location: Fcon Power Writer
Posts: 4,338
Likes: 0
Received 0 Likes
on
0 Posts
I've got a scoobysport downpipe and nurspec back/centre...
Rob
AFAIK as long as the downpipe to centre section flange is the same size it doesnt matter..
Rob
AFAIK as long as the downpipe to centre section flange is the same size it doesnt matter..
01 August 2002, 09:34 PM
#3
Scooby Regular
Thread Starter
Join Date: Nov 2001
Location: the middle bit
Posts: 8,238
Likes: 0
Received 0 Likes
on
0 Posts
Cheers Rob so have u got the straight 3" scoobysport un or 3" to 2.5" DP? Also may i enquire if u did both DP & Blitz at same time or if not how much difference did either make on previous set up, noise etc?
Ta
Si
Ta
Si
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
1
17 September 2015 10:42 AM
robbie1988
Wanted
2
13 September 2015 09:25 AM
Scooby-Doo 2
Wheels And Tyres For Sale
1
09 September 2015 06:51 PM