Fabrication marks in pipes
#1
I've got myself an up-pipe & exhaust manifold sitting on the floor waiting to be fitted, & have been poking about in its tubes . There's bits - in both of them - of splatters of welding (I think it is anyway) & I'm wondering if I should worry about it. I'm sure with a couple of fingers remaining at the end I could get rid of it, but is it worth it? If it came off I'm thinking of the hideous things it could do to the turbo although, on the good side, maybe I'd then have to get a better turbo...
#2
Doubt that it would be an issue, if Subaru thought it necessary they would have ensured that the parts are 'cleaned' prior to fitting them.
But...if I were building an engine I would clear out the pipework.
Good luck, MD.
But...if I were building an engine I would clear out the pipework.
Good luck, MD.
Thread
Thread Starter
Forum
Replies
Last Post
Mattybr5@MB Developments
Full Cars Breaking For Spares
28
28 December 2015 11:07 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
18 November 2015 07:03 AM