JW Racing single pod A-pillar fitting, MY00
14 July 2003, 01:54 PM
#1
Scooby Regular
Thread Starter
Join Date: Aug 2002
Location: Essex!!
Posts: 2,039
Likes: 0
Received 0 Likes
on
0 Posts
Thanks Jamie for such a quick delivery of the above part.
1 small problem is that I can't get it to fit properly.
Starting from the bottom, we got it under the dash, but it doesn't fit flush against the existing pillar at the top.
It's holding in place, even without the velcro on it at the moment, but it doesn't fit properly at the top and looks a bit poor because of it.
Any suggestions on how to get it to fit? Am I doing something stupid? or is this one that came out of the mould a bit funny?
Thanks
1 small problem is that I can't get it to fit properly.
Starting from the bottom, we got it under the dash, but it doesn't fit flush against the existing pillar at the top.
It's holding in place, even without the velcro on it at the moment, but it doesn't fit properly at the top and looks a bit poor because of it.
Any suggestions on how to get it to fit? Am I doing something stupid? or is this one that came out of the mould a bit funny?
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
aaron_ions
General Technical
17
03 November 2021 11:07 AM
Scott@ScoobySpares
Full Cars Breaking For Spares
61
11 January 2021 03:08 PM
aaron_ions
General Technical
1
17 September 2015 10:42 AM