Making it talk
06 January 2009, 10:31 PM
#1
Making it talk
I need a program to read out selected documentation.. I'm doing my CCNA and get bored just reading..
Any suggestions.. I've been using a program that I need to copy and paste the words into.. I want one that will read with a key stroke when selected ..
06 January 2009, 11:46 PM
#4
Ah ok,
Something along these lines
Reading disability software – a computer program that reads text out loud!
Something along these lines
Reading disability software – a computer program that reads text out loud!
07 January 2009, 05:07 PM
#6
Scooby Regular
Join Date: Mar 1999
Location: The Great White North
Posts: 25,080
Likes: 0
Received 0 Likes
on
0 Posts
If you have a Mac then you should be able to open the document and select all the text, and then, from the Services menu (It is found under the Applications' menu) select the "Start speaking text" command from the Speech menu. It will then read the text to you using whatever voice you have configured.
By default the Start/Stop speaking commands do not have key combinations attached, but you can very easily configure key combinations for this.
If you're on 10.5 then I'd recommend using the "Alex" voice. You can configure the voice settings via the "Speech" preference pane.
By default the Start/Stop speaking commands do not have key combinations attached, but you can very easily configure key combinations for this.
If you're on 10.5 then I'd recommend using the "Alex" voice. You can configure the voice settings via the "Speech" preference pane.
Last edited by Markus; 07 January 2009 at 05:11 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Sam Witwicky
Engine Management and ECU Remapping
17
13 November 2015 10:49 AM