ATI 9700 - a quick question about powering it...
#1
Scooby Regular
Thread Starter
Just bought an ATI 9700 card. It says it needs to be powered from the MOBO. No problem, but as this is my first card that needs to do this, where does it take the power from?
Can I assume that you power the card with the additional floppydrive power connector?
any advice for a numbnut
Dan
Can I assume that you power the card with the additional floppydrive power connector?
any advice for a numbnut
Dan
#2
Scooby Regular
Join Date: Mar 2001
Location: Derbyshire
Posts: 4,496
Likes: 0
Received 0 Likes
on
0 Posts
I got a splitter cable with my 9700 which, as you have said, splits the floppy drive power. One end then goes onto the 9700, the other into the floppy drive.
That's from memory about 4 months ago, but I think it's right!
That's from memory about 4 months ago, but I think it's right!
#5
Scooby Senior
You may have a spare one in the case already. My 9700 Pro used a floppy-type connector, whereas the 9800 Pro uses the hard-drive type of connector.
Thread
Thread Starter
Forum
Replies
Last Post
ossett2k2
Engine Management and ECU Remapping
15
23 September 2015 09:11 AM