Simon C

I've got a nice big dollop of it on the rear quater. Sadly its a hazard of my hobby, not usually this bad, but the land owners just sent the fellers in and loads of trees are dropping resin in large volumes.

Myles

iTrader: (40)

Clay it off?

Mark_S

Olive oil was recommended to me for removing resin which was still sticky/soft, worked for me. If its hardened not too sure.

V4JDMSTi

iTrader: (2)

Wash with usual foam and 2bm routine but add in a citrus degreaser after the initial jet wash down. If that doesn't get it fully then soak a micro fibre in hot water and hold on without aggitating. Then use t&g. Should do the trick. I wouldn't clay incase any grit is in the resin. Polish afterwards and seal. Try to get a good few layers of wax on there over a day or 2 and it should make it easier to remove in future.

Simon C

Bit big to clay. its a 1" x 2" drop!!! Being resin its hardened too.