Hi,

about 1 week ago my speedo counter stopped working, but all the others dials are working fine, rev, fuel and water temps!
can some one tell me how to fix the problem or how to solve it?
thanks

 

nobody can help me??

 

Speed sensor(vehicle speed sensor) can be the damaged,not sure if you are running OE ECU would check for errors via JGM guide

http://www.jollygreenmonster.com/error_codes.asp.htm


Jura

 

Hi thanks but sadly it's not an OE ECU, is's an HYDRA one, and remapped by JGM .

 

On a 1996 car, the speedo is run by a cable (speedo cable) rather than a wire, I think?

If so, it may have become diosconnected at either end, behind the dash or at the gearbox. Check that BOTH ends are in tight.

If they are, then it's the speedo head itself, time to look on ebay.....


And no, it's NOT an easy task to change for the later dials, sorry.

 

thanks mate, but, I don't know nothing about electric/mechanic work so, do you have a pic for boths ends (dash and gearbox)?

 

No chance. For a start mine is the newer electronic type, and secondly, neither are particularly easy to photograph, nor interesting.

The speedo cable will be black, stiff, about 10mm diameter, the ends plastic and wider. You normally pinch the ends to insert, or remove them. If you remove the clocks, you'll see the upper end.
two screws from the TOP of the binnacle, looking upwards, then three to hold the clocks in once that bezel is removed, just pull the clocks forwards.

If they come too easy, suspect the cable is unattached. Try pushing it back into place.

The lower end is best got at with the car on a ramp, but you CAN slide under with it jacked and properly supported.

 

lol to much "professional" work for me, I'll ask a friend of mine who's mechanic to check both ends and fix it, is possible.
anyway many thanks for your usefull help mate! !
cheers

 

Hope it's something cheap and easy.