Notices
ScoobyNet General General Subaru Discussion

SIDE DOORS PROTECTION STRIP

Thread Tools
 
Search this Thread
 
Old Mar 15, 2002 | 08:33 AM
  #1  
Vinesh's Avatar
Vinesh
Thread Starter
Scooby Regular
 
Joined: Jul 2001
Posts: 1,795
Likes: 0
Question

How much does one of these side protector strip cost?

Anyone got a picture of it on a Silver MY99 Impreza?

Finally is it easy to put on?

Cheers
Reply
Old Mar 15, 2002 | 09:33 AM
  #2  
akshay67's Avatar
akshay67
Scooby Regular
 
Joined: Nov 2001
Posts: 2,342
Likes: 0
Post

£50

I haven't put mine on yet as the stick stuff doesn't feel sticky enough! But looks relatively easy.

I think there is a silver scoob in the gallery section that has it.
Reply
Old Mar 15, 2002 | 09:59 AM
  #3  
BuRR's Avatar
BuRR
Scooby Regular
 
Joined: Dec 2001
Posts: 5,210
Likes: 0
From: Was Wakefield, now London
Post

The sticky stuff is deceptively sticky, let me assure you. Once its on, it will grip like buggery.

I used some trim tape from Halfords, too.

Run a strip of trim tape down the centre of the strip, and expose the sticky from the trim tape - this will hold the strip in place while you take the backing off the white ones that come on it as standard. Before you put it on the car, just pull a pit of the orange backing off a bit so its exposed down from the strip once its flush with the doors. You can now slide out the orange backing and the strip will be well-stuck.

Seriously, get it right first time, or you'll have a nightmare.
Reply
Old Mar 15, 2002 | 10:05 AM
  #4  
akshay67's Avatar
akshay67
Scooby Regular
 
Joined: Nov 2001
Posts: 2,342
Likes: 0
Post

BuRR,

Does the Halfords trim tape flush mount with the orange bits? How long ago did you buy this as I'll need to see if they still stock it.
Reply
Old Mar 15, 2002 | 10:58 AM
  #5  
whip's Avatar
whip
Scooby Regular
 
Joined: Mar 2001
Posts: 443
Likes: 0
Talking

I took some time to mark out the upper line where I wanted it to sit (I used some tape to do this). I then peeled back the orange tape a bit at a time, lined it up, peeled back a bit more etc and just moved the whole way along til I was finished.

One word of caution: make sure you pay attention to how far along you position the door strips, as they can chafe on the panel or the adjacent strip if you're not careful, which could lead to the edge of the strip being pulled off over a period of time. The first side that I did was fine but the second set were slightly longer and I ended up having to trim a little off the end of one so that it wouldn't catch when the door was opened.

Whip
Reply
Old Mar 15, 2002 | 11:01 AM
  #6  
BuRR's Avatar
BuRR
Scooby Regular
 
Joined: Dec 2001
Posts: 5,210
Likes: 0
From: Was Wakefield, now London
Post

I did mine about a month ago.
Reply
Old Mar 15, 2002 | 01:12 PM
  #7  
TonyBurns's Avatar
TonyBurns
Scooby Regular
iTrader: (3)
 
Joined: Aug 2000
Posts: 25,565
Likes: 2
From: 1600cc's of twin scroll fun :)
Post

Mine have been on since the first month, dont really notice them now but then again ive got no dents either
They look funny to start with but grow on you saves the hassle but i got my dealer to put them on for me so no probs there (except the fitting of! an extra 45 quid! )

Tony
Reply
Old Mar 15, 2002 | 02:01 PM
  #8  
DavidLewis's Avatar
DavidLewis
Scooby Regular
 
Joined: Apr 1998
Posts: 1,864
Likes: 0
Post

If your "sticky stuff" doesn't seem "sticky" try warming it up with a hairdryer before applying
Reply
Old Mar 15, 2002 | 04:10 PM
  #9  
Boost II's Avatar
Boost II
Scooby Regular
iTrader: (1)
 
Joined: Dec 2000
Posts: 1,727
Likes: 0
From: Herts.
Lightbulb

Also if you **** up, just re-heat your sticky stuff with a hair dryer, peel back the strip and repostion - the original adhesive will still work fine.
Reply
Old Mar 15, 2002 | 05:38 PM
  #10  
NBW's Avatar
NBW
Scooby Regular
 
Joined: May 2001
Posts: 877
Likes: 0
Post

Like this? Fitted by dealer from new, 18 months ago. One section on front wing did start to come off within a week, replaced by dealer and no problems since then:




Tim


[Edited by NBW - 3/15/2002 5:41:27 PM]

[Edited by NBW - 3/15/2002 5:41:58 PM]
Reply
Old Mar 15, 2002 | 06:37 PM
  #11  
TonyBurns's Avatar
TonyBurns
Scooby Regular
iTrader: (3)
 
Joined: Aug 2000
Posts: 25,565
Likes: 2
From: 1600cc's of twin scroll fun :)
Talking

Best 50 quid ive spent on the car saves the cost of mr dent doesnt it

Tony
Reply
Old Mar 16, 2002 | 08:03 AM
  #12  
Vinesh's Avatar
Vinesh
Thread Starter
Scooby Regular
 
Joined: Jul 2001
Posts: 1,795
Likes: 0
Post

Thanks for all the replys, I will have the strips done next week. At least it will save my doors from any dents.
Reply
Old Mar 16, 2002 | 09:16 AM
  #13  
Hndatch627's Avatar
Hndatch627
Scooby Regular
 
Joined: Mar 2002
Posts: 43
Likes: 0
Post

i just have the factory ding strips and i can't tell you how many flat spots are in them that would normally be dings...it seems that people no longer care about anyone else's car except their own. I hate dings and anything that can be used to help protect against them i am all for. I also hate cracked headlights/lenses so i used the 3M adhesive protectors and have been one of the few RS's in the area that survived winter w/o a rock hole in a foglamp or headlight.

jeremy
Reply
Old Mar 16, 2002 | 03:59 PM
  #14  
Ray_li's Avatar
Ray_li
Scooby Regular
 
Joined: Jan 2002
Posts: 7,161
Likes: 0
Post

Has anyone got them colour coded on their car, if so picture please.

would it look better if it was colour coded?
Reply
Old Mar 16, 2002 | 07:35 PM
  #15  
darms's Avatar
darms
Scooby Regular
25 Year Member
Liked
iTrader: (5)
 
Joined: Jan 2001
Posts: 2,614
Likes: 1
From: Jedi
Arrow

I've been advised that the compound of the strips are too soft, and that if they are colour coded - the paint would chip off quite easy.

Worth checking with a body shop.....

Reply
Old Mar 16, 2002 | 09:30 PM
  #16  
mark_wrx's Avatar
mark_wrx
Scooby Regular
20 Year Member
 
Joined: Aug 2001
Posts: 277
Likes: 0
Wink

does anyone know who sells them apart from dealers as i got a import. thanx
Reply
Old Mar 17, 2002 | 12:21 PM
  #17  
silver's Avatar
silver
Scooby Regular
 
Joined: Apr 2000
Posts: 61
Likes: 0
Post

Vinesh
I had the strips shown on the silver scoob fitted by my dealer last year. I was really sceptical when I collected the car as they looked like they would fall off if I so much as touched them with a damp sponge. However the dealer said they would not and he has been proved correct.
steve
Reply
Old Mar 17, 2002 | 02:17 PM
  #18  
navigator's Avatar
navigator
Scooby Regular
 
Joined: Aug 2001
Posts: 562
Likes: 0
Post

darms
i was told the same, that the paint would chip off when it flexed so had the strips in black. i understand some on the bbs have had them colour coded.
pays ya money and takes your choice.
As a ding preventer they are bery good.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
KAS35RSTI
Subaru
27
Nov 4, 2021 07:12 PM
Mattybr5@MB Developments
Full Cars Breaking For Spares
12
Nov 18, 2015 07:03 AM
FuZzBoM
Wheels, Tyres & Brakes
16
Oct 4, 2015 09:49 PM
Ganz1983
Subaru
5
Oct 2, 2015 09:22 AM
Jamesh10
General Technical
3
Oct 1, 2015 11:56 PM




All times are GMT +1. The time now is 08:53 PM.