Ok fitted a set of spec c seats into my wrx. 10/10 improvement btw. So i disconnected the seat air bags cos the new seats dont have them in the new seats but now the airbag warning light is up now (which i expected) but how do i cancel this? Short the wires or fit a resistor (what ohms?) help would be appreciated! Cheers

Ollie

 

This was asked before, someone said take the airbag warning bulb out from behind the dash

 

yeh but when the light is illuminated then the other airbags dont work so dont think this is the way to go!

 

Dont have a clue have cant remember any other answers, someone should be a auto electrician here

 

3 Ohm resistors should be what you need.

 

I have the exact same problem...
https://www.scoobynet.com/interior-1...ing-light.html

 

I did this on the Forester, was dead easy.

Get some resistors from Maplins, 3 ohm sounds right from memory. Fold the wires over double and insert them into the connector for the airbags, bit of electrical tape to keep it all secure and Bobs your proverbial..

 

excellent guys will try this now and will get back to you with results!