Whats the maximum Bar you can run a standard TD05 at.

Cheers

Dean

 

About 1.4-1.5 i'd imagine.

 

I believe it can run to about 1,7 bar, but since it comes with different compressors it may not be the same for a TD05-16H and a TD05-20G...

 

I was talking about 16g. Not sure the rest!

 

Cheers

Its on a MY95 Jap WRX. So what gram would that be...

 

If it is the original one and it has not been rebuild it is a TD05-16G capable of proberly close to 1,5 bar.

 

...btw - I do not think the G has anything to do with gram. TD05-16G is a TD05 house with a 16G compressor.

 

OK Cheers. Currently running 1.2 so once Ive finished most of my bits I should have a bit extra to go when I get it mapped.

 

If you have upgraded the fuel pump and injectors you are proberly right.

 

Yep would agree with above.

i think RobG on here tried to see how much a TD05 could take and Im sure he said got to 2.0bar but it didnt last long. lol

 

2 bar I think 1.5 should be a good improvement from the 1.2 im running now. Just fitted my Front Mount. Next is the SS Manifold then the Walbro and the injectors to go before the Remap.

What injectors are on now and what will I need to go up to? the 440's?

Cheers

Dean

 

Hi Dean. Hows it going? What you got planned then?

 

Hi Mate hows it going...

Just had a FMIC fitted. Next is the manifold and up pipe. Then the injectors and fuel pump. Finally the remap.. Was going to go for the apexi fc and controller. You had yours done at Power Station didnt you. What was the price all in all.

Dean

 

I had mines done at http://www.zenperformance.co.uk/. You'll be best off speaking to Paul about your requirements. He's a top bloke, and prices are very reasonable too. I've had a few more bits done too, like you now have FMIC.

 

They seem to live at 1.7 to 1.8 bar. Gearbox and engine might not though.

 

440s fine

 

Cheers Mate