Wheel-arch mud guards...
#1
Scooby Regular
Thread Starter
I'm trying to take off the front bumper (MY95) - can get all the lights off etc, but the mud guarding in the wheel arch is proving a little difficult to remove...
Any ideas how to get it all off?
Thanks in advance.
Dan
Any ideas how to get it all off?
Thanks in advance.
Dan
#2
Scooby Regular
Hmmm
I had mine out today as I was fitting mudflaps, anyway there are a few large plastic screws that you turn 1/2 a turn and then pop them out, then you pop out the plastic surround that the screw was inside. Then look for the small plastic screws, these you gently unscrew all the way and again remove the surrounds. Then you 'll see that the arch guard just falls out.....
easy !!!
good luck
Dan
I had mine out today as I was fitting mudflaps, anyway there are a few large plastic screws that you turn 1/2 a turn and then pop them out, then you pop out the plastic surround that the screw was inside. Then look for the small plastic screws, these you gently unscrew all the way and again remove the surrounds. Then you 'll see that the arch guard just falls out.....
easy !!!
good luck
Dan
#3
When you have the plastic arch cover off treat all the metal surfaces under it with waxoyl or similiar after cleaning out all the muck you'll find . The front wings are a notorious rust spot on scoobys . The arch covers trap the muck above them and the only way to clean it is removing the covers . I found this out too late and the bottom of the wing next the drivers door is held together with isopon P40 .
Thread
Thread Starter
Forum
Replies
Last Post
shorty87
Full Cars Breaking For Spares
19
22 December 2015 11:59 AM