Couldn't Get It Going
#1
Scooby Regular
Thread Starter
Join Date: Jan 2000
Location: Disco, Disco!
Posts: 21,825
Likes: 0
Received 0 Likes
on
0 Posts
Parked my car on in town to do a bit of shopping. Came back an hour or so later. Alam remote didn't deactivate the alarm. Opened the door with the key, the alarm did not go off. found the PIN code and inputted it into the keypad alarm set, inputted the code again, the alarm the deactivated. Called the local dealers who had not heard of this before. They suggested that i try the other key fob. I duly fetched ot from home and it works a treat. The battery light comes on in the original key, tried swapping the batteries over. Still no joy with the original. Good job i had the PIN number stored safely on my person. Anyone else had a similar alarm experience?
#2
Only a possibility but if your code changes every time you press the button like mine, (Cobra) then using two remotes (if you have done) can sometimes disrupt the sequence. With mine the instructions show you how to reset them.
Good Luck
Good Luck
#3
If its a recent car the alarm is I believe a Sigma unit that changes codes each time the button is pressed, If the button is pressed more than about 10-30 times the remote goes out of synch. remotes can be easily re-programmed. It is a common problem I've done it to both of mine before I realized My alarm dealer took about 5 mins to reprogram mine for nothing.
#4
Scooby Regular
Thread Starter
Join Date: Jan 2000
Location: Disco, Disco!
Posts: 21,825
Likes: 0
Received 0 Likes
on
0 Posts
To Harry & Paul W
Thanks for the advise.
I sounds like i must stop fiddling with the remote, think i was probably doing that whilst braving the crowds and shop assistants on Saturday.
I will get the remote into the dealer and get it reprogrammed.
Paul
Thanks for the advise.
I sounds like i must stop fiddling with the remote, think i was probably doing that whilst braving the crowds and shop assistants on Saturday.
I will get the remote into the dealer and get it reprogrammed.
Paul
#5
Just a thought to add confusion..............
It has also been known that mobile phone transmitters nearby can screw your remotes cause of their signal strength.
Now i`m no electronics eng. but seen this on "watchdog" type programme months ago.
It has also been known that mobile phone transmitters nearby can screw your remotes cause of their signal strength.
Now i`m no electronics eng. but seen this on "watchdog" type programme months ago.
Thread
Thread Starter
Forum
Replies
Last Post
Wingnuttzz
Member's Gallery
30
26 April 2022 11:15 PM