where is the engine coolant sensor
I know where the one pronged one is but I don't know where the two pronged one is that goes to the ecu. Also by replacing this will I have to drain the coolant like when fitting the one pronged sensor.
My car is an MY95 WRX.
My car is an MY95 WRX.
Scooby Regular
Joined: Mar 2002
Posts: 4,338
Likes: 0
From: Fcon Power Writer
It is underneath the inlet manifold on a cross pipe that runs from one side of the block to the other and then out to the top rad hose.
If you follow the pipe that the top rad hose goes onto it is about 8 inches back along this pipe and on the back (facing the rear)
Orange connector, pig to get off
Rob
If you follow the pipe that the top rad hose goes onto it is about 8 inches back along this pipe and on the back (facing the rear)
Orange connector, pig to get off
Rob
Scooby Regular
iTrader: (5)
Joined: Jan 2001
Posts: 1,559
Likes: 0
From: Hampshire - now trying an M3
Scooby Regular
Joined: May 2002
Posts: 2,148
Likes: 0
From: Scotland
Thread
Thread Starter
Forum
Replies
Last Post