Cheers mate. There are some in the Galley somewhere of her but need to take some fresh ones me thinks.

 

Can this be done to a STI UK 2002 clocks?
Or can the clocks be changed?

 

No your clocks have to be changed. Sweep will only work on clocks that light up red+go dark when the ignition is switched off. These clocks can be fitted into uk bug and blobeyes with a bit of modding.

 

What will I need in parts and cost?
Cheers.

 

As said, this thread pretty much says it all. https://www.scoobynet.com/scoobynet-...snt-sweep.html

Post #50 explains what it says in the owners' manual which IMO is the most accurate.

 

Mine do the sweep and its a Spec-C and not imported by litchfields

 

That car wssnt imported by Litchfields H

 

were you able to get yours to do it Suberman?

 

No. Because it doesn't have the feature at all, so there's no way to turn in on, unlike on a regular JDM STI.

The other guys with a hawkeye Spec C with this feature i suspect must've had it "enabled" by the importer or the owner. Litchfield apparently can enable it on a hawkeye Spec C.

I'm not 100% sure why or if the blob Spec Cs came with this. I'll see if i can find some info on this.

 

Ok, this is for the rev counter setting and not the sweeping dials.

Tony

 

As I said Suberman if you have the clock that light up red/go dark when you switch the ignition off ALL these do or can do the sweep. JDM imprezas come with it all ready programed in and you can turn it on and off. Spec C needs the code for this function entered into the chip on the back of the clock that stores your mileage, dccd setting, out side temp etc etc.

Your link to post 50 says Spec C don't do it which is correct but it doesn't say that they can not do it.

 

You will need to buy theses. You can usualy find someone on here selling them or on ebay.


This is a link to the guid to fitting them and what you need to do. its quite simple mod to do.

http://www.scoobymods.com/showthread...sti+gauges+wrx

Hope this helps.

 

Yes Andy, that's what i'm saying in post #50 (might have misread my post ). The hawkeye Spec Cs do not have the sweep function programmed in from the factory (i.e. you cannot "switch" it on at will, you'd have to get it programmed). I did say that the guys with hawkeye Spec Cs with the sweep function probably had it programmed by the supplier or a previous owner (as confirmed by Robocop and Shaun that it is possible)

Again from post #39 from this thread. Below

 

Cheers,
From reading there are issues with some warning lights and not rev buzzer, has this been resolved or another method.
Mine is very late 02 STI

 

The rear diff light is of no use to you as your rear diff wont have the sensor.

Only thing you will loose is the buzzer sound when you hit your set gear change rev limit and as far as i know there has been no fix for the abs light but as the guy say just stick a bit of black insulating tape over the light but leave a little showing so should your abs fail the light will go off. The propper way to fix this is wire the abs circuit so the light comes on when it fails.

 

We've before this JDM speedo on our wagon and everything worked like should,buzzer too and start up sweeping sequence too


Jura