spoke with Rob last night who said it's easier to remove the BV off the intercooler then you get get access to the pipe easierand also put th eT bar lower down so it's not as on show.

The pipe off the BV looks bigger than the T pipe fitting, is it bigger and you just use the tie clips to make it hold on?

 

The pipe for the recirc valve is quite thick walled and the Subaru supplied Tee is designed to fit it. Why not just pull it off and see for yourself whether the Blue Tee will fit?

Here is an early picture of where my take off sits (black Tee piece in my case)



MY pressure sensor is mounted on the Bulkhead bracket for the pitch stopper.
If you want send me a copy of the fitting instructions.

 

Sorry to bring up an old thread!!

but I have the same kit but trying to put it into a legacy gtb 2008

i don’t have the plugs that make this plug and play the l person I bought the gauge from cut it off ..
am I able to just wire into that plug with the pink tape around it ?

 

If you find it and there's enough room to work on it, then yes.
BUT you would be better off purchasing a version of the "goodwill connector"
AFAIK Current part numbers are (depending upon Subaru model fitted to)
H0077AG021
H0077YC000
H0077AJ001
H0077AL000

 

Thanks ! Not sure if that will work as I still need to wire that harness in.

surely it’s just

battery
illumination
ignition
ground?