08/09 Hatches, Stand up and show yourselves!!!
Scooby Regular
iTrader: (4)
A reasonable constructive day - I managed to sort the rest of my engine bolts (Bar the one that is missing from the pack 😫 ) and give her a full clean and wax. My first time with the Autoglym HD wax and got to say it's pretty good.
Also first pics with my near rear light overlays fitted (Thanks to Salsa for super quick delivery 👍🏼 ).
A few more bits to sort before Spring RaceDay and Castlecombe in a few weeks, anyone else going?
Also first pics with my near rear light overlays fitted (Thanks to Salsa for super quick delivery 👍🏼 ).
A few more bits to sort before Spring RaceDay and Castlecombe in a few weeks, anyone else going?
Scooby Regular
iTrader: (4)
Scooby Regular
iTrader: (4)
Scooby Regular
iTrader: (3)
Join Date: Nov 2013
Location: swindon
Posts: 995
Likes: 0
Received 0 Likes
on
0 Posts
Scooby Senior
so....... did you move to a bigger house
welcome back
Scooby Senior
Scooby Regular
iTrader: (1)
***** to that plus I think it looks better with spoiler in standard position
Scooby Regular
iTrader: (4)
I have the maximum height on mine.
Scooby Regular
iTrader: (3)
Join Date: Nov 2013
Location: swindon
Posts: 995
Likes: 0
Received 0 Likes
on
0 Posts
Scooby Senior
Scooby Regular
iTrader: (4)
Scooby Regular
Iv got wing risers aswell and they don't cause me any Agro and I'm 6ft 2" , I wanted to change the rear a bit without putting a stupid WRC spoiler on the back and I think the risers do just enough for me
Scooby Regular
Mine needed the cables to stop the spoiler stabbing into the roof but they are easy to fit and you don't notice them ,, to be honest I didn't test it without them but I'm fairly sure mine would hit the roof without them
Scooby Regular
Mine opens wide enough for anything iv needed to get in there and could prob open a bit more if I got a bit closer with the spoiler
Scooby Regular
Thread Starter
Scooby Regular
Hi, bought a 2008 STI Hatch last June that was being sold on here and now lives out in Malta. Been slowly working through a few little issues and remapping it for our climate and fuel, plus wasn't happy with the map it was on (over boosting past target).
- Does anyone have any good geometry setting for fast road when running BC coilovers?
- Exhaust is a H&S 3 inch turbo back with no cats but a centre Res. I still think it's too noisy at idle and general driving. Anyone recommend something quieter/more neighbour friendly given am not planning to put cats back in?
- Does anyone have any good geometry setting for fast road when running BC coilovers?
- Exhaust is a H&S 3 inch turbo back with no cats but a centre Res. I still think it's too noisy at idle and general driving. Anyone recommend something quieter/more neighbour friendly given am not planning to put cats back in?
Scooby Regular
iTrader: (13)
Originally Posted by STI450
- Does anyone have any good geometry setting for fast road when running BC coilovers?
RCM choose these geo. settings for normal + fast road:
Front Toe: 1.25mm in
Front RH Camber: -1.3 Degrees
Front LH Camber: -1.3 Degrees
Rear Toe: 1.5mm in
Rear RH Camber: -1.0 Degrees
Rear LH Camber: -1.0 Degrees
You might need rear camber bolts to adjust the rear camber (I have Eibach ones fitted).
Also, if you like your coilovers set to the extreme end (whether full soft or full hard), then don't go right to the last click. Go to 5 clicks from the end, then a further 2 = 7 total.
Last edited by joz8968; 13 March 2017 at 09:34 PM.
Scooby Regular
iTrader: (1)
Scooby Regular