Neutral position switch issue on Bugeye
#32
hi lads ive got a 2001 bugeye wrx which recently keeps throwing up am missfire on cylinder 2,car runs ok,sometimes a bit juddery changed plugs thinking it was that but still doing it..which one is cylinder 2 anyway.
Should mention that its been remapped few years ago now,decat exhaust from the turbo,uprated fuel pump,and green air filter...
can anyone help keep reading so many things it could be???????
Should mention that its been remapped few years ago now,decat exhaust from the turbo,uprated fuel pump,and green air filter...
can anyone help keep reading so many things it could be???????
#33
Scooby Regular
iTrader: (2)
Join Date: Feb 2012
Location: Aberdeenshire
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
Just thought I would add mt tuppence worth... even though its an old post.
Last edited by wrxyz; 11 May 2013 at 09:27 AM.
#34
Scooby Regular
iTrader: (2)
Join Date: Feb 2012
Location: Aberdeenshire
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
hi lads ive got a 2001 bugeye wrx which recently keeps throwing up am missfire on cylinder 2,car runs ok,sometimes a bit juddery changed plugs thinking it was that but still doing it..which one is cylinder 2 anyway.
Should mention that its been remapped few years ago now,decat exhaust from the turbo,uprated fuel pump,and green air filter...
can anyone help keep reading so many things it could be???????
Should mention that its been remapped few years ago now,decat exhaust from the turbo,uprated fuel pump,and green air filter...
can anyone help keep reading so many things it could be???????
why not post your question as a new thread, it will get a better response; also, a wee tip.... check the date of the post,
#35
Might try that if it comes on again,still bloody juddery,changed the fuel filter today,but still the same???
#36
Hi guys, I recently had the garage take the gearbox out to change a plastic geat inside that drives the speedo sensor (luckily I had it under warranty). Before it went in it also had a fault light on and I was getting it stalling at idle when coming to a stop, when they checked it out is was MAF sensor code, they just reset it and cleaned the MAF sensor, after that it continued to stall intermittently and the fault light can back on, after taking it back and them checking it again this time it said MAP sensor, they replaced that with new one from Subaru dealer. Then today I got another fault, when they checked it it said Neutral Switch Circuit low. They cleared it and it hasn't come back on yet. I looked in the engine bay at the wiring harness, there appears to be a spare plug near to the gearbox oil dip stick, not sure if they have forgot to plug something in or if its a spare for STI version or something? Its a 2004 WRX.
Getting Pi**ed off with taking it back, strange how its been 3 different fault codes though, any advice would be great.
Getting Pi**ed off with taking it back, strange how its been 3 different fault codes though, any advice would be great.
#37
So far, everyone changes NPS because of a CEL or they notice problems when remap is done. But did anyone check how sensor works after some miles?
I regulary log with delta dash, and I will need to change my third NPS. For me they last around 6-10k miles, then they start to lose signal in high gears when accelerating hard.
Does any one have the same expirience?
I regulary log with delta dash, and I will need to change my third NPS. For me they last around 6-10k miles, then they start to lose signal in high gears when accelerating hard.
Does any one have the same expirience?
Thread
Thread Starter
Forum
Replies
Last Post