2hrs, 50' of exhaust wrap &....
#33
Drag it!
iTrader: (1)
Join Date: Jun 2002
Location: Flame grilled Wagon anyone?
Posts: 9,866
Likes: 0
Received 0 Likes
on
0 Posts
You have to remove the downpipe, to get access to 2 of the 5 nuts that hold the up pipe to the turbo.
My procedure:
Remove down pipe.
Remove the OEM Manifold
Unbolt the 5 nuts at top of turbo (2 DP Side, 3 Turbo side)
Release the up pipe from turbo (leave turbo where it is)
Undo drivers side engine mount bolt
Jack drivers side of engine up appro 1/2 inch
Remove OEM up pipe
Lower Engine
Re bolt engine mount nut (depending on headers you may have to undo again)
Fit new headers
Re fit down pipe
My procedure:
Remove down pipe.
Remove the OEM Manifold
Unbolt the 5 nuts at top of turbo (2 DP Side, 3 Turbo side)
Release the up pipe from turbo (leave turbo where it is)
Undo drivers side engine mount bolt
Jack drivers side of engine up appro 1/2 inch
Remove OEM up pipe
Lower Engine
Re bolt engine mount nut (depending on headers you may have to undo again)
Fit new headers
Re fit down pipe
#34
Scooby Regular
Thread Starter
Join Date: Jan 2001
Location: Down South to Ooop North to Back Down South again!!
Posts: 6,633
Likes: 0
Received 0 Likes
on
0 Posts
Mmmm I had the downpipe off, the intercooler off, the induction off & i'd undone the up-pipe from the rest of the manifold. I was told that the up-pipe would come out with the turbo attached by taking it upwards?
#35
Drag it!
iTrader: (1)
Join Date: Jun 2002
Location: Flame grilled Wagon anyone?
Posts: 9,866
Likes: 0
Received 0 Likes
on
0 Posts
It will
IF
You unbolt the oil feed, the water feed and the water return, and then pull hard to take the turbo out the oil return pipe.
BUT
that is one long winded and awkward way of doing it.
IF
You unbolt the oil feed, the water feed and the water return, and then pull hard to take the turbo out the oil return pipe.
BUT
that is one long winded and awkward way of doing it.
#41
Scooby Regular
Join Date: Mar 2001
Location: Focus RS slightly modified!!
Posts: 1,716
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Jolly Green Monster
Hey the big fella can wrap man.. wiiicky wiiicky wild! lol
Bryan
#42
Former Sponsor
iTrader: (4)
Join Date: Jan 2001
Location: ECU Mapping - www.JollyGreenMonster.co.uk
Posts: 16,548
Likes: 0
Received 2 Likes
on
2 Posts
Originally Posted by RB5108
You aint bad at mapping either, thank's for your help and support yesterday I owe you beer or two I just wish my mrs was so understanding
Bryan
Bryan
Hopefully you will have the car sorted this week.. let me know when you pick her up and I'll try and be there / meet you to check the map.
See your project thread, if you need 380s to borrow etc..
Thanks
Simon
Thread
Thread Starter
Forum
Replies
Last Post
fatboy_coach
General Technical
15
18 June 2016 03:48 PM