3D Printed Front Door Speaker Spacers
15 December 2018, 05:34 PM
#31
Scooby Regular
15 December 2018, 05:42 PM
#33
Scooby Regular
02 January 2019, 11:10 PM
#39
Scooby Regular
I'll take the newage rear ones please pm me payment info
02 January 2019, 11:32 PM
#40
Scooby Regular
Payment sent
03 January 2019, 03:31 PM
#43
Scooby Regular
27 May 2019, 01:01 AM
#48
Scooby Newbie
Join Date: Aug 2013
Location: manchester
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Hi, Could someone please confirm how much clearance fitting these give you? I've seen some 6.5inch speakers that are about 4inches deep overall (including the magnet). Any idea if these would fit? Thanks
27 May 2019, 10:20 AM
#49
4inches? They're huge. You have less than 50mm clearance in the door. So you'd need to mount the speakers 50mm+ away from the door. But then you'd never get the door cards to fit. I have speakers with 69mm depth and I had to trim the inside of the door cards to fit. I don't believe you'd be able to fit anything bigger without cutting holes in the cards.
27 May 2019, 10:33 AM
#50
The bass face ones in the pictures have a mounting depth of 73mm and fit ok, for reference.
Without the 19mm brackets the magnet interfered with the glass. Don't know the clearance in the installed condition but I'd bet it's not much.
Without the 19mm brackets the magnet interfered with the glass. Don't know the clearance in the installed condition but I'd bet it's not much.
27 May 2019, 09:49 PM
#51
Scooby Newbie
Join Date: Aug 2013
Location: manchester
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply guys....I've taken the plunge and bought them. They are Rockford Fosgate T162S. I've just rechecked and think the mounting depth is 2.9 inches so 68mm ish? Hopefully will be able to get them in with a little bit of trimming as per Technopug.
Last edited by davedung; 27 May 2019 at 09:52 PM. Reason: mistake
Thread
Thread Starter
Forum
Replies
Last Post