skylinelee

iTrader: (1)

Before I break something.... Is there a special way to remove my Godspeed 330mm front discs, brembo calliper came off no probs with the 2 bolts but disc won't move..do I have to tap it with a hammer...? Driveshaft nut is off and those 5 little hex bolts are out...?
What have I done wrong ?
Cheers
Lee

forgedmarco

iTrader: (10)

Don't need to take drive shaft but off or hex screws normally. There's normally a couple of holes with threads in, screw in a bolt an it'll push the discs off.

forgedmarco

iTrader: (10)

Nut*

skylinelee

iTrader: (1)

Is it the 2 little holes in the pic ?
Cheers

forgedmarco

iTrader: (10)

Yep the 2 either side of the hub nut the disc just slides off

skylinelee

iTrader: (1)

Cheers pal, thanks a lot
Lee

Fonzey

iTrader: (5)

M8 IIRC

forgedmarco

iTrader: (10)

I was going to put that but wasn't quite sure no problem mate it's what the forum is for

skylinelee

iTrader: (1)

Nice one Fonzey,
Haha feel like a newbie even tho I've been on here since 2003
Cheers
Lee

Fonzey

iTrader: (5)

I've got a pair of M8 bolts taped to my brake bleeding kit so I know where they are

You need to use two and just wind them in at a similar pace and it will just pop off.

I used a bit of copper grease when refitting disks so hopefully it won't bind so much, but not sure if that's best practice or not.

alcazar

iTrader: (2)

And do remember to do a scrupulous clean of the hub mating surface before greasing lightly and refitting the new.
Or it can end up running out of true.